Lantronix ETS Reference Manual - page 233
Command Reference
Set/Define Server Commands
12-71
See Also
Show/Monitor/List Server, page 12-108; Reloading Operational Software,
page 3-7; Editing the Boot Parameters, page 3-7.
12.46.19 Set/Define Server Lock
Controls whether or not local users rare permitted to Lock their ports. When a port is locked, the active
session or connection cannot be used until the port is unlocked. This is desirable when you want to leave a
console running, possibly with privileged status enabled, without having to worry about security
considerations.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
See Also
Lock, page 12-16; Enabling Server-Wide Port Characteristics, page 4-1;
Locking a Port, page 5-15.
12.46.20 Set/Define Server Login Password
Specifies the password that is used to log into the ETS from a serial port or the network when Port Password
is Enabled. If the password is not given on the command line, the user will be prompted for it; it will not be
displayed when typed.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
passwd
Enter a password of up to 6 alphabetic characters.
Examples
Local> SET SERVER LOGIN PASSWORD
Password> platyp (not echoed)
Verification> platyp (not echoed)
Local>
See Also
Set/Define Port Password, page 12-45; Login Password, page 3-9.
SET
DEFINE
SERVER LOCK
ENABLED
DISABLED
SET
DEFINE
SERVER LOGIN PASSWORD
[
]
passwd
[
]