Lantronix ETS Reference Manual - page 206

Set/Define Port Commands

Command Reference

12-44

Note:

In the absence of a PortList or the All parameter, the configuration will affect the 

current port only.

See Also

Set/Define Port DSRlogout, page 12-37; Show/Monitor/List Ports, page 12-

102; Dedicated SLIP, page 5-5.

12.43.25   Set/Define Port Name

Sets a unique name for each port. Remote LAT connections to the ETS can use either a service name or the 

port name to identify a port for connection purposes. 

Applies To

EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P

Restrictions

You must be the privileged user to use this command.

Parameters

PortList/All

Specifies a particular port or group of ports, or all ports. Port numbers are 

specified with integers between 1 and the total number of physical ports. Lists 

of ports must be separated by commas. Ranges of ports must be separated by 

a dash (-).

Note:

In the absence of a PortList or the All parameter, the configuration will affect the 

current port only.

portname

A 16 character name composed of alphanumeric characters or the underscore 

(_) character. The default is Port_n, where n is the port number. If the name is 

not enclosed in quotation marks, it will be converted to uppercase.

Examples

Local> SET PORT NAME “HighSpeed_Modem”

See Also

Show/Monitor/List Ports, page 12-102; Port Names, page 5-13.

12.43.26   Set/Define Port Parity

Sets the serial port’s parity. Using Mark or Space will change a port set for 8 bits character size to 7 bits 

automatically. Changing the parity back will not automatically change the character size.

Applies To

EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P

SET

DEFINE

 PORT 

PortList

ALL

 NAME portname

SET

DEFINE

 PORT 

PortList

ALL

 PARITY 

ODD

EVEN

MARK

SPACE

NONE