Lantronix ETS Reference Manual - 12.48.2   Set Session Echo

Command Reference

Set Session Commands

12-93

Parameters

ServiceName

The hostname to which LAT users will connect, up to 16 characters long. An 

identification string showing it is a Telnet connection to the host will be added 

if not specified.

Examples

Local> SET SERVICE hydra VIRTUAL ENABLED

See Also

Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111;

LAT and TCP/IP Connectivity, page 2-15.

12.48   Set Session Commands

12.48.1   Set Session Delete

Allows you to change what is sent to the remote TCP/IP host when you press the Delete key. This command 

has no effect in Local mode or on LAT sessions, nor does it have any effect if Passthru or Passall is in effect. 

This command and the Set Session Newline command may be helpful if you are getting odd output from a 

Telnet session. 

Applies To

EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P

Errors

An error is returned if no sessions are active.

Parameters

Delete

Sends a delete character (ASCII 0x7f) when the Delete key is pressed.

Backspace

Sends a backspace character (ASCII 0x8, Ctrl-H) when the Delete key is 

pressed.

Examples

Local> SET SESSION DELETE BACKSPACE

See Also

Set Session Newline, page 12-94; Set Session Passall, page 12-95; Set Session 

Passthru, page 12-95.

12.48.2   Set Session Echo

Requests that the ETS perform local echoing for TCP connections. The default is Disabled, on the 

assumption that the remote host will provide echoing.

SET SESSION DELETE 

DELETE

BACKSPACE

SET SESSION ECHO 

ENABLED

DISABLED