Lantronix ETS Reference Manual - 9.3 Troubleshooting
Troubleshooting
LAT Host Setup
9-6
cmd
Either Start, Show, or Stop. Start will create the server process, Show will
show the process’s current status, and Stop will kill the server process.
dir
The directory out of which the download files will be loaded.
dev
The LAT device, if different from the default LTA9777.
log
The name of the file to which status data from the server will be written.
The configuration parameters must be specified in order, and cannot be left out unless you are ending the
command line, as in the next example.
Figure 9-22: Syntax Example
You can use the VMS command Show System to ensure the download process started properly. To shut
down the server process, enter the following command:
Figure 9-23: Shutting Down a Server Process
Managers can use the Source command on the ETS to attempt to download a configuration file and test the
functionality of the download server before actually using the download file at boot time. See the Source
entry in the Command Reference chapter for more details.
The ETS must be able to find the VMS host in order to utilize the download process. If the node limit on
the ETS is set to zero, it may not be able to locate the VMS host. For downloading to work reliably, ensure
that the ETS node limit is non-zero.
See Set/Define Server Node Limit on page 12-75 for more information on node limits.
9.3 Troubleshooting
9.3.1 VMS Printer Troubleshooting
If a remote print queue is not functioning properly, check the following items:
◆
Make sure that LAT is licensed on your ETS, if applicable. The LAT license number, obtained from
your dealer or Lantronix, can be configured with the Set/Define Protocols LAT License command.
◆
Verify that the LTAnnnn device is mapped to the correct server and port/service name. Use the
LATCP Show Port LTAnnnn command to see what server/service combination the LTA device is
mapped to.
◆
Verify that the ETS name matches the information obtained via Show Port LTAnnnn.
◆
On your ETS, verify that the server and port/service names specified match the names obtained via
Show Port LTAnnnn, and
VMS> @SYS$STARTUP:ETS$STARTUP START -
VMS>_ DUA0:[RAPIDPRINT] LTA5000:SYS$MANAGER:ETSLOG.DAT
VMS> @SYS$STARTUP:ETS$STARTUP STOP