Lantronix ETS Reference Manual - page 254
Set/Define Service Commands
Command Reference
12-92
12.47.19 Set/Define Service Telnetport
Specifies a TCP listener socket for this service. TCP connections to the socket are accepted or rejected based
on the availability of the service. Unlike the TCPport option, a Telnetport socket will perform Telnet IAC
negotiations on the data stream.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
portnum
Enter a socket number of 4000 to 4999.
None
Clears any previously-configured Telnetport. No Telnetport is configured by
default.
Note:
Either a TCPport or a Telnetport may be configured for a service, but not both.
See Also
Clear/Purge Service, page 12-7; Set/Define Service TCPport, page 12-91;
Show/Monitor/List Services, page 12-111; TCP/Telnet Service Sockets, page
4-14.
12.47.20 Set/Define Service Virtual
Creates a LAT “service” from a TCP/IP hostname. When LAT users connect to this proxy service, they are
given a Telnet session with the specified host.
Note:
The Disabled option currently does nothing; use Clear/Purge Service on page
12-7 instead.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Errors
If the host is not reachable or resolvable at connection time, the connect
attempt will fail.
SET
DEFINE
SERVICE ServiceName TELNETPORT
portnum
NONE
SET
DEFINE
SERVICE ServiceName VIRTUAL
ENABLED
DISABLED