Lantronix ETS Reference Manual - 12.52.13 Show/list Slip
Show/Monitor/List Commands
Command Reference
12-112
Displays information about the current port’s sessions or all sessions.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use the Monitor Sessions command. Secure
users cannot specify Port or All.
Examples
Local> SHOW SESSION
Local> SHOW SESSION PORT 5
See Also
Set Session Commands, beginning with Set Session Delete, page 12-93;
Chapter 6, Using the ETS.
12.52.13 Show/List SLIP
Displays the current or saved SLIP entries. If a port number is specified, that port’s connections and SLIP
counters will be displayed. The List command displays permanently-configured address/port pairs, as well
as any configured SLIP default options.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Errors
The Port option cannot be specified with List.
See Also
Clear/Purge SLIP, page 12-8; Set/Define SLIP, page 12-95; Serial Line
Internet Protocol (SLIP), page 2-12; SLIP, page 4-6; Status Displays, page 6-9.
12.52.14 Show/Monitor/List SNMP
Displays the current or saved SNMP security table entries.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
See Also
Clear/Purge SNMP, page 12-8; Set/Define SNMP, page 12-98; Simple
Network Management Protocol (SNMP), page 2-13; SNMP Security, page 4-
18; Status Displays, page 6-9.
SHOW
LIST
SLIP PORT portnum
[
]
SHOW
MONITOR
LIST
SNMP