Lantronix ETS Reference Manual - page 253
Command Reference
Set/Define Service Commands
12-91
See Also
Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111;
Reverse Telnet (RTEL), page 2-13.
12.47.17 Set/Define Service SOJ
Specifies a string to be sent to the attached device at the start of every access, regardless of network protocol.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
StartString
Any ASCII characters, or a backslash and two hex digits.
None
Clears any previously-configured string.
Examples
Local>> DEFINE SERVICE myserv SOJ \45
See Also
Clear/Purge Service, page 12-7; Set/Define Service EOJ, page 12-86; Show/
Monitor/List Services, page 12-111.
12.47.18 Set/Define Service TCPport
Specifies a TCP listener socket for this service. TCP connections to the socket are accepted or rejected based
on the availability of the service.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
portnum
Enter a socket number between 4000 and 4999.
None
Clears any previously-defined TCPport. No TCPPort is configured by default.
Note:
Either a TCPport or a Telnetport may be configured for a service, but not both.
See Also
Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111;
TCP/Telnet Service Sockets, page 4-14.
SET
DEFINE
SERVICE ServiceName SOJ
StartString
NONE
SET
DEFINE
SERVICES ServiceName TCPPORT
portnum
NONE