Lantronix ETS Reference Manual - 12.40 Set/define Logging
Command Reference
Set/Define Logging
12-25
12.40 Set/Define Logging
Controls error and event logging on the ETS. A destination host must be defined before logging levels can
be configured. If the host is disabled, the configured logging events will be saved, and will take effect when
the host is re-enabled.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
Host hostname
Specifies the host to which event logs are sent. Hosts are specified by entering
a hostname followed by one of the following: a double colon (::) for LAT
hosts, a single colon (:) for TCP/IP hosts, a backslash (\) for NetWare
fileservers, or the word “console” if logging events are to be sent to a console
terminal.
Note:
The host must be configured to support logging. See Event Logging on page 4-
18 for more information.
None
Clears any enabled event logs, and the log host name.
Commands
Logs all commands that users type.
Modem
Logs all incoming and outgoing modem activity, including modem jobs.
Network
Logs network events. This is useful when diagnosing network problems.
Printer
Logs printer-related activities (on-line/off-line conditions, job status, etc.).
Security
Logs authorization-related activity, such as user logins.
System
Logs system-related activity, including ETS boots and log file access.
SET
DEFINE
LOGGING
HOST hostname
NONE
COMMANDS
NETWORK
PRINTER
SECURITY
SYSTEM
ENABLED
DISABLED