Lantronix ETS Reference Manual - page 217
Command Reference
Set/Define Port Commands
12-55
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
username
A username can be up to 16 characters long. The name is converted to all
uppercase unless it is enclosed in quotes.
None
Removes any previously-configured username. No username is configured by
default.
Examples
Local> SET PORT USERNAME “Ted Smith” COMMAND COMPLETION
ENABLED
See Also
Show/Monitor/List Ports, page 12-102; Port Names, page 5-13.
12.43.43 Set/Define Port Verification
Determines whether the ETS will issue informational messages whenever a session is connected,
disconnected, or switched. It is disabled by default.
Dedicating a port will disable port verification. See Set/Define Port Dedicated on page 12-34 for more
information.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to enter this command for a port other than
your own (the current port).
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Show/Monitor/List Ports, page 12-102; Other Port Characteristics, page 5-11;
Port Messages, page 5-13.
SET
DEFINE
PORT
PortList
ALL
VERIFICATION
ENABLED
DISABLED