Lantronix ETS Reference Manual - page 195
Command Reference
Set/Define Port Commands
12-33
12.43.10 Set/Define Port Character Size
Sets the number of bits per character for the serial port. Character size defaults to 8 bits.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to change the character size of a port other than
your own.
Errors
Autobaud will only work for 8 bits, or for 7 bits with Even parity.
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Examples
Local> SET PORT CHARACTER SIZE 7
See Also
Set/Define Port Autobaud, page 12-28; Set/Define Port Parity, page 12-44;
Set/Define Port Stop, page 12-52; Show/Monitor/List Ports, page 12-102;
Parity, Character Size, and Stop Bits, page 5-4.
12.43.11 Set/Define Port Command Completion
Enables or disables the command completion feature. If enabled, the ETS will attempt to complete partially
typed command words when the user presses the Space or Tab key. If the entry is ambiguous (or if the user
types an option), the ETS will send a beep to the terminal.
Applies To
EPS1, EPS2, EPS2-100, EPS4-100EPS4, ETS4P, ETS8, ETS8P, ETS16,
ETS16P
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
SET
DEFINE
PORT
PortList
ALL
CHARACTER SIZE
[
]
7
8
SET
DEFINE
PORT
PortList
ALL
COMMAND COMPLETION
[
]
ENABLED
DISABLED