Lantronix ETS Reference Manual - page 197
Command Reference
Set/Define Port Commands
12-35
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
Local portname
Specifies a dedicated connection to another port on the same unit.
None
Clears any previously-defined dedicated service.
Rlogin hostname
Specify an Rlogin host to use for the Dedicated connection. Either a text host
name or an IP address can be used.
Service ServiceName
The port is dedicated to the specified service.
Destination port
Specifies a connection to a particular port on the dedicated host. This is
desirable when more than one port offers the same service.
NodeName
Specifies a connection to a particular node on the dedicated host. This is
desirable when more than one node offers the same service.
EnvString
Sets up the connection environment before the session is started. The string is
constructed with a sequence of key letters, some of which are prefaced by
either “+” or “-.” The generic key letters are:
Table 12-5: Environment Strings
Letter
Action
D
Backspace Mode (+D) or Delete Mode (-D)
E
Local Echo Mode (+E) or Remote Echo Mode (-E)
I
Interactive Mode
P
Passall Mode (+P) or Passthru Mode (-P)
C
CR becomes CRLF (+C) or CR becomes LF (-C)
T
TCP Mode (raw uninterpreted data stream)
R
Rlogin protocol (sets port number to 513 if not already set)