Lantronix ETS Reference Manual - page 186
Set/Define IPsecurity
Command Reference
12-24
Parameters
IPaddress
Specifies the IP address to restrict based on the additional parameters entered.
The IP address can be a full IP address, such as 192.0.1.80. It can also be
expressed as a partial address, such as 192.0.1.255, to restrict entire sub-
networks.
An address with a 0 in any segment implies Incoming and Outgoing Disabled.
An address with a 255 in any segment applies to all the addresses in that range.
Both
Restricts logins from the network into the ETS and Telnet sessions to the
network from the ETS.
Incoming
Restricts logins from the network into the ETS, and connections to the serial
port.
Outgoing
Restricts Telnet sessions to the network from the ETS.
Ports portlist
Restricts connections to this address from certain ports, and connections from
this address to the specified ports. If a portlist is not specified, all physical and
virtual ports apply.
Printing
Restricts TCP/IP printing for this address. The restriction applies to LPR and
RTEL print connections, but not to direct port or service socket connections.
SLIP
Restricts SLIP sessions for the specified address or range of addresses.
Examples
Local> SET IPSEC ADDR 192.0.1.255 INC ENA OUT DIS
Local> SET IPSEC 134.0.1.255 Port 3,5-7
See Also
Clear/Purge IPsecurity, page 12-6; Show/Monitor/List IPsecurity, page 12-
100; IP Security Table, page 4-16.