Lantronix ETS Reference Manual - 11: Lan Manager Host Setup
11-1
11: LAN Manager Host Setup
The EZWebCon configuration software is the easiest way to configure the ETS. See your Installation Guide
for more information on using the EZWebCon software.
Note:
The ETS must be added as a Windows NT printer before it can accept print jobs
from a Windows NT host.
An ETS servicing LAN Manager print queues must have the LAN Manager protocol enabled (the default).
To verify that LAN Manager is enabled, enter the List Protocols command.
11.1 Printing Methods
Command line users can configure the ETS to use the Berkeley remote LPR software. See LPR on Windows
NT 3.5.1 (and later) on page 7-4 for LPR configuration instructions. The following sections cover DLC and
NetBIOS protocol configuration for Windows NT hosts.
Note:
There are also third-party LPR implementations; contact Lantronix Technical
Support for more information.
11.1.1 DLC
To use the DLC protocol, you must associate the DLC characteristic with a service.
Figure 11-1: Enabling DLC
Open the NT Print Manager; its icon is located in the Main window of the Windows Program Manager. If
the printer driver isn’t already installed, you will need to install it from your Windows NT installation disks.
To create a printer to use with DLC, complete the following steps.
1
From the Printer menu, choose Create Printer.
Figure 11-2: Create Printer Dialog Box
Local>> SET SERVICE NTX DLC ENABLED PORT 2