Lantronix ETS Reference Manual - page 211
Command Reference
Set/Define Port Commands
12-49
12.43.32 Set/Define Port Remote Configure
Controls whether actions on a remote LAT/VMS host are allowed to affect the local port on the ETS. If this
feature is enabled, the VMS Set Term/Speed command, for instance, will change the terminal server port
(using LAT) to the specified speed.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
PortList/All
Parameters
Port List/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Show/Monitor/List Ports, page 12-102.
12.43.33 Set/Define Port Security
Restricts a port’s access to terminal commands and its ability to get information about other ports.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note:
In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also
Show/Monitor/List Ports, page 12-102; Security, page 5-14.
SET
DEFINE
PORT
PortList
ALL
REMOTE CONFIGURE
[
]
ENABLED
DISABLED
SET
DEFINE
PORT
PortList
ALL
SECURITY
ENABLED
DISABLED