Lantronix ETS Reference Manual - page 238
Set/Define Server Commands
Command Reference
12-76
Limits the number of failures allowed when entering the privileged password while attempting to become
the privileged user. After this number of tries, the port will be logged out. The user can abort the password
process by pressing Ctrl-Z instead of typing the password.
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
limit
A value between 0 and 100. If 0 is specified, the port is never logged out for
too many password failures. The default is 3 retries.
None
Changes the retry limit to 0 (no limit).
Examples
Local> SET SERVER PASSWORD LIMIT 10
See Also
Set Privileged/Noprivileged, page 12-56; Set/Define Server Privileged
Password, page 12-76; System Passwords, page 3-8.
12.46.30 Set/Define Server Privileged Password
Sets the password for becoming the privileged user or “superuser” of the ETS. If the password is not
specified on the command line, the user will be prompted for it (it will not be displayed).
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions
You must be the privileged user to use this command.
Parameters
passwd
Enter a password of up to 6 alphanumeric characters.
Examples
Local> SET SERVER PRIVILEGED PASSWORD “yodel”
See Also
Set Privileged/Noprivileged, page 12-56; Set/Define Server Password Limit,
page 12-75; System Passwords, page 3-8.
12.46.31 Set/Define Server Prompt
Allows the system administrator to change the prompt that users see (the default is Local_x>).
Applies To
EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
SET
DEFINE
SERVER PRIVILEGED PASSWORD
[
]
passwd
[
]
SET
DEFINE
SERVER PROMPT PromptString