Oki B412dn User Manual - page 171
Admin Setup
This function is displayed only if you log in as an administrator of the printer.
Device PIN and User Settings (Editing)
Printing can be controlled per user.
Network Setup
Item
Description
General Network Settings
Sets a network protocol.
Wireless
Sets the wireless settings.
TCP/IP
Sets TCP/IP information.
Setting the Network According to the Usage Environment and Application
NBT
Sets NetBIOS over TCP information.
Sets E-mail settings.
Checking the Status of the Printer and Error by E-mail
SNMP
Sets SNMP information.
Checking the Status of the Printer by Using SNMPv3
IPP
Sets the function that enables you to perform IPP print.
IEEE802.1X
Sets IEEE802.1X/EAP information.
Connecting the Printer to the Authentication Network by Using IEEE802.1X
Security
Protocol
ON/OFF
Sets a network protocol and whether to turn the network service on or off
IP Filtering
Restricts access by using IP addresses. Access from outside your company is also supported. However,
this function requires sufficient knowledge about IP addresses. Some settings may result in serious
problems that prevent you from accessing the printer via a network.
Limiting by Using IP Addresses (IP Filtering)
MAC Address
Filtering
Restricts access by using MAC addresses. Access from outside your company is also supported.
However, this function requires sufficient knowledge about MAC addresses. Some settings may result
in serious problems that prevent you from accessing the printer via a network.
About the Web Page of the Printer
Limiting by Using MAC Addresses (MAC Address Filtering)
SSL/TLS
Encrypts communications between a computer or mobile device (client) and the printer.
Encrypting Communication with SSL/TLS
IPSec
Sets the encryption for communications between a computer (client) and the machine to prevent
tampering.
Encrypting Communication with IPSec
Change
Network
Password
Changes the network password. The default value of the password is the last six digits of the MAC
address.
Maintenance Reset/Restore Restarts and resets a network. Even if you access the Web page from the Web browser after
restarting, the Web page is not displayed until the restart is complete. Resetting restores the IP
address to its default status, resulting in information you set being lost. In such a case, the Web page
cannot be displayed.
Setting or Checking by Opening the Web Page of the Printer
Network
Scale
This setting is intended for more efficient operation on a network. This setting is very effective for such
cases as where a hub that has the spanning tree function is used, or a computer and the printer are
connected one-on-one with a cross cable.
170