Oki B412dn User Manual - page 459
Connecting with WPS
If a wireless LAN access point supports WPS, you can easily connect to the wireless LAN with the button for simple setting (WPS button).
Connect by following the procedure below.
1.
Check the position of the WPS button by referring to the instruction manual that is included in a
wireless access point or other document.
2.
Check that the wireless LAN access point starts and is operating properly.
3.
Turn the printer on.
4.
Press or on the operator panel to display [WIRELESS SETTING], and then press (OK).
5.
Enter the administrator password, and then press (OK).
The factory default password is "aaaaaa".
6.
Press or to display [WPS SETUP], and then press (OK).
7.
Press or to display [WPS-PBC], and then press (OK).
8.
Select [YES], and then press (OK).
The printer starts searching for wireless LAN access points. When the search is in progress, press and hold the WPS button on a
wireless LAN access point for a few seconds.
When the setting completion screen is displayed, the setting of the wireless LAN is complete.
Note
You cannot operate the panel when WPS is in progress.
Memo
If the [CONNECT FAILED] is displayed, repeat the procedure from step 8.
If [OVERLAP] is displayed, multiple WPS push buttons are pressed at two or more wireless access points. Wait for a while,
and then try again.
Topics
Checking That Connection is Established Correctly
458