Oki B412dn User Manual - page 460
Selecting a Wireless Access Point from the Operator Panel to Connect
If a wireless access point does not support WPS, you can specify a wireless LAN access point you want to use from the wireless LAN
access points that the printer detects to establish a connection. You must enter an encryption key to establish a connection.
Set by following the procedure below.
1.
Check the SSID and encryption key by referring to the instruction manual that is included in a wireless
access point or other document, and write the information down.
Memo
An SSID is also called a network name, ESSID, or ESS-ID.
An encryption key is also called a network key, security key, password, or Pre-shared Key.
2.
Check that the wireless LAN access point starts and is operating properly.
3.
Turn the printer on.
4.
Press or to display [WIRELESS SETTING], and then press (OK).
5.
Enter the administrator password, and then press (OK).
The factory default password is "aaaaaa".
6.
Press or to select [WIRELESS SELECTION], and then press (OK).
The printer starts searching for wireless LAN access points. Wait for a while.
A list of SSIDs of valid wireless LAN access points is displayed.
7.
Press or to select a wireless LAN access point, and then press (OK).
Note
If only [MANUAL SETUP] is displayed, or the SSID of the wireless access point you want to use is not included in the list, set by
following the procedure in "
Setting from the Operator Panel Manually to Connect
The encryption key entry screen that is suitable for the encryption method of the selected wireless LAN access point is displayed.
8.
Enter the encryption key.
Memo
The encryption key varies depending on the wireless LAN access point or security.
If the [ENTER WPA KEY] message is displayed
Item
Description
Security
WPA2-PSK
Encryption key
Enter the Pre-shared Key.
If the [PLEASE SET IN WEB] message is displayed
Item
Description
Security
WPA2-EAP
Set from the Web page of the printer.
Using the Web page of the Printer
If neither of the above two cases is applied
Item
Description
Security
Disable
Encryption key
No entry is required.
The SSID of the wireless LAN access point that you selected in step 7 is displayed on a confirmation screen, and one of the
encryption methods above is also displayed as Security.
459