Oki B412dn User Manual - page 582
23.
Click [Add] on the [IP filter lists] screen.
24.
Click [Add] on the [IP filter lists] screen.
25.
Click [Next] on the [IP Filter Wizard] screen.
26.
Click [Next] on [IP Filter Description and Mirrored property] screen.
27.
Click [Next] on [IP Traffic Source] screen.
28.
Click [Next] on [IP Traffic destination] screen.
29.
Click [Next] on [IP Protocol Type] screen.
30.
Click [Finish].
31.
Click [OK] on the [IP filter lists] screen.
32.
Select a new IP filter from the list on the [Security Rule Wizard], and then click [Next].
33.
Click [Add] on the [Filter Action] screen.
34.
Click [Next] on [Filter Action Wizard] screen.
35.
Enter [Name] and [Description] on the [Filter Action Name] screen, and then click [Next].
36.
Select [Negotiate security] on the [Filter Action General Options] screen, and then click [Next].
37.
Select [Do not allow unsecured communication.] on the [Communicating with computers that do not
support IPSec] screen, and then click [Next].
38.
Select [CUSTOM] on the [IP Traffic Security] screen, and then click [Settings].
39.
Set on the [Custom Security Method Settings] screen, and then click [OK].
Note
Set AH and ESP so that these settings can be the same as the settings that you set in "Phase2 Proposal" in "
".
40.
Click [Next] on the [IP Traffic Security] screen.
41.
Select the [Edit properties] check box, and then click [Finish].
42.
If you want to enable Key PFS, select the [Use session key perfect forward secrecy (PFS)] check box in
the [New Filter Action Properties] screen.
43.
If you perform IPSec communication with the IPv6 global address, select the [Accept unsecured
communication, but always respond using IPSec] check box.
44.
Click [OK].
45.
Select the new filter action, and then click [Next].
46.
Select the authentication method on the [Authentication Method] screen, and then click [Next].
47.
Click [Finish].
48.
Select [OK] on the [New IP Security Policy Properties] screen.
49.
Select the new IP security policy on the [Local Security Policy] screen.
50.
Select [Assign] from the [Action] menu.
581