Oki B412dn User Manual - page 581
Setting a Computer
Memo
Set the printer before setting the computer.
1.
Click [Start], and then select [Control Panel] > [System and Security] > [Administrative Tools].
2.
Double-click [Local Security Policy].
3.
Click [IP Security Policies on Local Computer] on the [Local Security Policy] screen.
4.
Select [Create an IP Security policy] from the [Action] menu.
5.
Click [Next] on [IP Security Policy Wizard] screen.
6.
Enter [Name] and [Description], and then click [Next].
7.
Clear the [Activate the default response rule (earlier versions of Windows only).] check box, and then
click [Next].
8.
Select the [Edit properties] check box, and then click [Finish].
9.
Select the [General] tab on the [New IP Security Policy Properties] screen.
10.
Click [Settings].
11.
Enter a value (minutes) on [Authenticate and generate a new key after every] in the [Key Exchange
Settings] screen.
Note
Specify the same value as [LifeTime] in the "Phase1 Proposal" setting in "
". Enter a value in minutes in this
step even if [LifeTime] is specified in seconds.
12.
Click [Methods].
13.
Click [Add] on the [Key Exchange Security Methods] screen.
14.
Specify [Integrity algorithm], [Encryption algorithm], and [Diffie-Hellman group].
Note
Select the same value specified in [IKE Security Algorithm], [IKE Hash Algorithm], and [Diffie-Hellman group] in the "Phase1
Proposal" setting in "
15.
Click [OK].
16.
Click [OK] on the [Key Exchange Security Methods] screen.
17.
Click [OK] on the [Key Exchange Settings] screen.
18.
Select the [Rules] tab on the [New IP Security Policy Properties] screen.
19.
Click [Add].
20.
Click [Next] on [Security Rule Wizard] screen.
21.
Select [This rule does not specify a tunnel] on the [Tunnel Endpoint] screen, and then click [Next].
22.
Select [All network connections] on the [Network Type] screen, and then click [Next].
580