Oki B412dn User Manual - page 290
ECO MODE
ON
If set to [ON]: In the case of making a small number of prints, printing starts even when the fuser
has not reached the specified temperature.
If set to [OFF]: Printing starts when the fuser reaches the specified temperature.
CLRABLE
WARNING
ONLINE
Sets the timing to remove the display of warnings that can be cleared.
AUTO
CONTINUE
OFF
Sets whether to automatically recover the printer when a memory overflow occurs.
MANUAL
TIMEOUT
60 SEC
Sets the time in seconds that it takes for the printer to cancel a job in paper feed waiting state
when printing with manual feed.
TIMEOUT
INJOB
40 SEC
Sets the printer's wait time (seconds) from the stoppage of data processing to the outputting of
the pages.
TIMEOUT
LOCAL
40 SEC
Sets the time to keep the ports open after a process is complete. (excluding network)
TIMEOUT
NET
90 SEC
Sets the time to keep the network port open after a process is complete.
LOW TONER CONTINUE
Sets the printer action to be taken when toner is low.
JAM
RECOVERY
ON
Sets whether to retry the printing of pages that were not printed due to paper jam after the paper
jam is cleared.
ERROR
REPORT
OFF
Sets whether to print an error report when an internal error occurs.
HEX DUMP
-
Prints data received from the host computer in hex dump. To end printing, turn off the printer.
PRINT ADJUST
Item
Factory default
setting
Description
POSITION
ADJUST
MP
TRAY
X
ADJUST
0.00 MILLIMETER
X correction: Corrects the position of the whole print image in the direction
perpendicular to the paper feed direction.
Available range: ±2.00 mm (in units of 0.25 mm)
Y correction: Corrects the position of the whole print image in the paper feed
direction.
Available range: ±2.00 mm (in units of 0.25 mm)
Duplex printing X correction: Corrects the position of the print image in the
direction perpendicular to the paper feed direction when printing the back side of
the duplex prints.
Available range: ±2.00 mm (in units of 0.25 mm)
Duplex printing Y correction: Corrects the position of the print image in the paper
feed direction when printing the back side of the duplex prints.
Available range: ±2.00 mm (in units of 0.25 mm)
Y
ADJUST
0.00 MILLIMETER
DUPLEX
X
ADJUST
0.00 MILLIMETER
DUPLEX
Y
ADJUST
0.00 MILLIMETER
TRAY1 X
ADJUST
0.00 MILLIMETER
Y
ADJUST
0.00 MILLIMETER
DUPLEX
X
ADJUST
0.00 MILLIMETER
DUPLEX
Y
ADJUST
0.00 MILLIMETER
TRAY2 X
ADJUST
0.00 MILLIMETER
Y
ADJUST
0.00 MILLIMETER
DUPLEX
X
ADJUST
0.00 MILLIMETER
DUPLEX
Y
ADJUST
0.00 MILLIMETER
PAPER BLACK SET
0
Corrects the variation in print that is caused by temperature difference. Change the
value when blurring occurs.
DARKNESS
0
Sets the print density.
SMR SETTING
0
Corrects the variation in print results that is caused by temperature and humidity
conditions, as well as differences in print density and the frequency of printing.
289