Oki B412dn User Manual - page 586
Setting by Using PEAP
The printer supports the IEEE802.1 authentication.
Set up the printer and the computer before following the procedure below.
Note
The setting may not work properly depending on your network environment.
About initial setup and IP address
The description below uses the following environment as an example.
Printer: B432dn
IP Address: 192.168.0.3 (the IP address that is used for setting up a computer)
192.168.0.2 (the IP address that is used for setting up the printer)
Subnet mask: 255.255.255.0
1.
Open the Web page of the printer.
About the IP Address of the printer
How to log in to the Web page
About the Web Page of the Printer
2.
Log in as the administrator.
How to log in as the administrator
About the Web Page of the Printer
3.
Select [Admin Setup].
4.
Select [Network Setup] > [IEEE802.1X].
5.
Select [Enable] from [IEEE802.1X].
6.
Select [PEAP] from [EPA Type].
585