Oki B412dn User Manual - page 596
Setting the Printer
This section describes how to set the printer to use DHCP.
The DHCP protocol is enabled by factory default, and you do not need to perform this procedure.
Memo
The following procedure uses Network Card Setup as an example. The descriptions in this manual may vary depending on your
software.
1.
Insert the "Software DVD-ROM" into a computer.
2.
When [AutoPlay] is displayed, click [Run Setup.exe].
3.
Select a language from the drop-down list.
4.
Read the license agreement, and then click [Agree].
5.
Click [Next].
6.
Select the model name of this printer, and then click [Next].
7.
Select [Network (Wired/Wireless)], and then click [Next].
8.
Click [Device Network Setup].
9.
Select the model name of this printer, and then click [Next].
10.
Select [Auto], and then click [Setup].
11.
Enter a password of this printer.
595