Oki B412dn User Manual - page 536
NETWORK SETUP
Item
Setting
Default setting
Description
TCP/IP
ENABLE
DISABLE
ENABLE
Sets whether to enable or disable TCP/IP.
NETBIOS
OVER TCP
ENABLE
DISABLE
ENABLE
Sets whether to enable or disable NETBIOS OVER TCP.
IP
ADDRESS
SET
AUTO
MANUAL
AUTO
Sets the method of assigning an IP address.
IPV4
ADDRESS
xxx.xxx.xxx.xxx If a cable is
connected
169.254.XXX.XXX
If a cable is not
connected
192.168.100.100
Sets an IP address.
SUBNET
MASK
xxx.xxx.xxx.xxx
Sets a subnet mask.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Sets a gateway (default router) address.
0.0.0.0 means no router.
WEB
ENABLE
DISABLE
ENABLE
Sets whether to enable or disable WEB.
TELNET
ENABLE
DISABLE
DISABLE
Sets whether to enable or disable TELNET.
FTP
ENABLE
DISABLE
DISABLE
Sets whether to enable or disable FTP.
IPSEC
ENABLE
DISABLE
DISABLE
This item is displayed and it can be disabled only when IPSec is set to valid.
SNMP
ENABLE
DISABLE
ENABLE
Sets whether enable or disable SNMP.
NETWORK
SCALE
NORMAL
SMALL
NORMAL
[NORMAL]: The printer operates effectively even if connected to a HUB with the
spanning tree function. However, the printer takes longer to start up if it is connected
to a small LAN that consists of two or three computers.
[SMALL]: This setting covers a small LAN that consists of two or three computers to a
large LAN, but the printer may not operate efficiently if it is connected to a HUB with
the spanning tree function.
GIGABIT
NETWORK
ENABLE
DISABLE
DISABLE
Sets giga-bit network support.
HUB LINK
SETTING
AUTO
NEGOTIATE
100BASE-TX
FULL
100BASE-TX
HALF
10BASE-T FULL
10BASE-T
HALF
AUTO
NEGOTIATE
Sets the hub linking method. Normally, select [AUTO NEGOTIATE].
FACTORY
DEFAULTS
EXECUTE
Sets whether to initialize the network menu.
535