Oki B412dn User Manual - page 532
Checking the Status of the Printer by Using SNMPv3
If you use an SNMP manager that supports SNMPv3, you can encrypt the printer management with SNMP.
Memo
You can set this setting on the Web page.
The description below uses the following environment as an example.
Printer: B432dn
IPv4 address of the printer: 192.168.0.2
1.
Open the Web page of the printer.
About the IP Address of the printer
How to log in to the Web page
About the Web Page of the Printer
2.
Log in as the administrator.
How to log in as the administrator
About the Web Page of the Printer
3.
Select [Admin Setup].
4.
Select [Network Setup] > [SNMP] > [Setting].
5.
Select a version to use in [STEP1. Select Mode.], and then click [To STEP2].
Memo
If you select [SNMPv3], you cannot confirm and set with SNMPv1. If you select [SNMPv3+v1], you can confirm information with
SNMPv1 and SNMPv3, but you can set with SNMPv3 only.
6.
Enter the SNMPv3 user name in [User Name] in [STEP2. SNMPv3 Detail].
7.
Enter an authentication passphrase in [Passphrase] in [Authentication Settings].
531