Oki B412dn User Manual - page 435
Installation Requirements
Installation Environment
Install the printer in the following environment.
Ambient temperature: 10℃ to 32℃
Ambient humidity: 20% to 80% RH (relative humidity)
Maximum wet bulb temperature: 25℃
Note
Use care to prevent condensation. It may cause a malfunction.
If installing your printer where the ambient humidity is 30% or below, use a humidifier or antistatic mat.
Do not install this machine in a location where temperature becomes high or near open flames.
Do not install this machine in a location where chemical reactions may occur (such as a
laboratory).
Do not install this machine near alcohol, thinners, or other flammable solvents.
Do not install this machine in a location within the reach of children.
Do not install this machine in an unstable location (such as on an unsteady stand or slanted
location).
Do not install this machine in a location with high level of humidity or dust, or in a location
where the machine is exposed to direct sunlight.
Do not install this machine in an environment where it is exposed to salty air or corrosive gas.
Do not install this machine in a location where it is exposed to a high level of vibration.
Do not install the printer in a location where its vent hole is blocked.
Do not install this machine directly on a thick rug or carpet.
Do not install this machine in a closed room or other locations with bad circulation and
ventilation.
If you use this machine in a small room continuously for an extended period of time, make sure
to ventilate the room.
Install this machine away from a source that emits strong magnetic fields or noise.
Install this machine away from a monitor or television.
Carry this printer by holding both its sides.
Installation Space
Install the printer on a flat surface that is wide enough to accommodate the legs of the machine.
Secure enough space around the printer.
Top view
Side view
434