Oki B412dn User Manual - page 458
Connecting to a Wireless LAN (Optional)
Connect the printer to a network by using a wireless LAN.
Note
The wireless LAN module (optional) may not be available in some countries and regions.
[Cautions] For using a wireless LAN
Read the following cautions carefully before using the printer in a wireless LAN environment.
The printer cannot connect to a wired LAN and wireless LAN at the same time. If using a wireless LAN, do not connect a LAN
cable to the printer.
If the printer is used in a wireless network environment, the printer does not enter Deep Sleep mode but enters Sleep mode.
Do not place any electric products that emit weak radio waves (such as microwaves or digital cordless telephones) close to the
printer.
If there is metal, aluminum sash, or a reinforced concrete wall between the printer and wireless access points, connections may be
harder to be established.
The communication speed of a Wireless LAN connection may be slower than that of a wired LAN or USB connection depending on
the environment. If you want to print big data such as a photo, it is recommended to print with a wired LAN or USB connection.
Preparations to use a wireless LAN
The printer can connect to a wireless LAN environment via wireless access points (WPS supported).
Check whether your wireless access point supports the following environment before using.
Item
Value
Standard
IEEE 802.11 a/b/g/n
Access method
Infrastructure mode
Checking the wireless LAN setting method
Check whether your wireless access point supports WPS, and then select a setting method.
If WPS is supported, refer to "
"; if it is unknown whether WPS is supported, refer to "
Point from the Operator Panel to Connect
If a wireless LAN access point supports WPS, you can connect to the wireless LAN with the WPS button.
Selecting a Wireless Access Point from the Operator Panel to Connect
If a wireless access point does not support WPS, you can specify a wireless LAN access point you want to use from the wireless LAN
access points that the printer detects to establish a connection.
Setting from the Operator Panel Manually to Connect
Set the wireless LAN access point information (the SSID, encryption method, and encryption key) manually to connect to the wireless
LAN.
Checking That Connection is Established Correctly
This section describes the procedure for checking by using the printer whether a connection to a wireless LAN is properly established.
457