Oki B412dn User Manual - page 456
Connecting with a LAN Cable (Network Connection)
If there is no DHCP server on a network, you must set the IP address on a computer or printer manually.
Even if you are instructed to set a unique IP address that is specified by your network administrator, Internet service provider, or router
manufacturer, you must set the IP address to the computer and printer manually.
Note
Complete the network setting of the computer before this procedure.
You must have the administrator rights for the computer.
If you set an IP address manually, contact your network administrator or Internet service provider for the IP address to use. If the
IP address is set incorrectly, the network may go down or Internet access may be disabled.
Memo
If you construct a small network that consists of only the printer and a computer, set IP addresses as shown below (according to
RFC1918).
For the computer
IP address: 192.168.0.1 to 254
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0 (Not used)
DNS server: Not used
Printer
IP address setting: Manual
IP address: 192.168.0.1 to 254 (Select a value different from the computer's IP address)
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
Network scale: Small
To set [NETWORK SCALE], select [ADMIN SETUP] > [NETWORK SETUP] > [NETWORK SCALE] > [SMALL] on the operator panel.
1.
Prepare a LAN cable and hub.
Prepare a LAN cable (category 5 or higher, twist pair, straight) and hub.
2.
Turn the printer and computer off.
3.
Attach the core to the LAN cable.
Wind the LAN cable in a double loop at 2 to 3 cm from the end of the cable, and then attach the core to the looped cable.
4.
Insert one end of the LAN cable into the network interface connector (1) of the printer.
455