H3C LS-3100-52P-OVS-H3 Operation Manual - Features
3-1
3
Features
The following sections provide an overview of the main features of each module supported by the
S5500-EI series.
Access Volume
Table 3-1 Features in Access volume
Features
Description
Ethernet Interface
This document describes:
z
Basic Ethernet Interface Configuration
z
Combo Port Configuration
z
Configuring Flow Control on an Ethernet Interface
z
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Interface
z
Configuring Loopback Testing on an Ethernet Interface
z
Configuring a Port Group
z
Configuring Storm Suppression
z
Setting the Interval for Collecting Ethernet Interface Statistics
z
Enabling Forwarding of Jumbo Frames
z
Enabling Loopback Detection on an Ethernet Interface
z
Configuring the MDI Mode for an Ethernet Interface
z
Testing the Cable on an Ethernet Interface
z
Configuring the Storm Constrain Function on an Ethernet Interface
Link Aggregation
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
z
Basic Concepts of Link Aggregation
z
Configuring an Aggregation Group
z
Configuring an Aggregate Interface
z
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Port Isolation
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
z
Introduction to Port Isolation
z
Configuring the Isolation Group
Service Loopback
Group
To increase service redirecting throughput, you can bundle multiple
service loopback ports into a logical link, called a service loopback group.
This document describes:
z
Introduction to Service Loopback Groups
z
Configuring a Service Loopback Group