H3C LS-3100-52P-OVS-H3 Operation Manual - page 1733
1-8
Displaying and Maintaining PoE
To do…
Use the command…
Remarks
Display the mapping between ID,
module, and member ID of all PSEs.
display poe device
Display the power state and
information of the specified PoE
interface
display poe interface [ interface-type
interface-number ]
Display the power information of a
PoE interface(s)
display poe interface power
[ interface-type interface-number ]
Display the information of PSE
display poe pse [pse-id ]
Display the power state and
information of all PoE interfaces
connected with the PSE
display poe pse pse-id interface
Display the power of all PoE interfaces
connected with the PSE
display poe pse pse-id interface power
Display all information of the
configurations and applications of the
PoE configuration file
display poe-profile [ index index|
name profile-name]
Display all information of the
configurations and applications of the
PoE configuration file applied to the
specified PoE interface
display poe-profile interface
interface-type interface-number
Available in
any view
PoE Configuration Example
Network requirements
The device provides power supply for PDs through PoE interfaces.
z
GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are connected to IP telephones.
z
GigabitEthernet 1/0/11 and GigabitEthernet 1/0/12 are connected to access point (AP) devices.
z
The power priority of GigabitEthernet 1/0/2 is critical.
z
The power of the AP device connected to GigabitEthernet 1/0/11 does not exceed 9,000
milliwatts.