H3C LS-3100-52P-OVS-H3 Operation Manual - page 95
1-6
Configuring LLDPDU TLVs
Follow these steps to configure LLDPDU TLVs:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Set the TTL multiplier
lldp hold-multiplier value
Optional
4 by default.
Enter
Ethernet
interface
view
interface interface-type
interface-number
Enter
Ethernet
interface
view/port
group view
Enter port
group view
port-group manual
port-group-name
Either of the two is required.
Configuration performed in
Ethernet interface view applies
to the current port only;
configuration performed in port
group view applies to all the
ports in the corresponding port
group.
Enable LLDP TLV sending
for specific types of LLDP
TLVs
lldp tlv-enable { basic-tlv { all |
port-description |
system-capability |
system-description |
system-name } | dot1-tlv { all |
port-vlan-id | protocol-vlan-id
[ vlan-id ] | vlan-name [ vlan-id ] } |
dot3-tlv { all | link-aggregation |
mac-physic | max-frame-size |
power } | med-tlv { all | capability |
inventory | location-id
{ civic-address device-type
country-code { ca-type
ca-value }&<1–10> | elin-address
tel-number } | network-policy |
power-over-ethernet } }
Optional
By default, all types of LLDP
TLVs except location
identification TLV are sent.
Specify the management
address and specify to
send the management
address through LLDPDUs
lldp management-address-tlv
[ ip-address ]
Optional
By default, the management
address is sent through
LLDPDUs, and the
management address is the IP
address of the interface of the
VLAN with the least VLAN ID
among those permitted on the
port. If the IP address of the
VLAN interface is not
configured, IP address
127.0.0.1 is used as the
management address. Refer to
VLAN Configuration in the
Access Volume for information
about VLAN.