H3C LS-3100-52P-OVS-H3 Operation Manual - page 173
1-7
z
Customer A1, Customer A2, Customer B1 and Customer B2 are edge devices on the customer
network.
z
Third-party devices with a TPID value of 0x8200 are deployed between Provider A and Provider B.
Make configuration to achieve the following:
z
Frames of VLAN 200 through VLAN 299 can be exchanged between Customer A1and Customer
A2 through VLAN 10 of the service provider network.
z
Frames of VLAN 250 through VLAN 350 can be exchanged between Customer B1 and Customer
B2 through VLAN 50 of the service provider network.
Figure 1-4 Network diagram for VLAN transparent transmission configuration
Configuration procedure
Make sure that the devices in the service provider network have been configured to allow QinQ packets
to pass through.
1) Configuration on Provider A
z
Configure GigabitEthernet 1/0/1
# Configure VLAN 10 as the default VLAN of GigabitEthernet 1/0/1.
[ProviderA] interface gigabitethernet 1/0/1
[ProviderA-GigabitEthernet1/0/1] port access vlan 10
# Enable basic QinQ on GigabitEthernet 1/0/1.
[ProviderA-GigabitEthernet1/0/1] qinq enable
[ProviderA-GigabitEthernet1/0/1] quit
z
Configure GigabitEthernet 1/0/2
# Configure GigabitEthernet 1/0/2 as a hybrid port and configure VLAN 50 as the default VLAN of the
port.