H3C LS-3100-52P-OVS-H3 Operation Manual - page 918
1-13
Creating an RPF Route
Network requirements
z
PIM-DM runs in the network and all switches in the network support IP multicast.
z
Switch B and Switch C run OSPF, and have no unicast routes to Switch A.
z
Typically, Receiver can receive the multicast data from Source 1 in the OSPF domain.
z
Perform the following configuration so that Receiver can receive multicast data from Source 2,
which is outside the OSPF domain.
Network diagram
Figure 1-5 Network diagram for creating an RPF route
Switch A
Switch B
Switch C
Vlan-int102
30.1.1.2/24
Vlan-int101
20.1.1.2/24
Vlan-int101
20.1.1.1/24
Vlan-int102
30.1.1.1/24
Source 1
Source 2
Receiver
40.1.1.100/24
10.1.1.100/24
Multicast static route
Vlan-int200
40.1.1.1/24
Vlan-int100
10.1.1.1/24
OSPF domain
PIM-DM
50.1.1.100/24
Vlan-int300
50.1.1.1/24
Configuration procedure
1) Configure
IP
addresses and unicast routing
Configure the IP address and subnet mask for each interface as per
Figure 1-5
. The detailed
configuration steps are omitted here.
Enable OSPF on Switch B and Switch C. Ensure the network-layer interoperation among Switch B and
Switch C. Ensure that the switches can dynamically update their routing information by leveraging the
unicast routing protocol. The specific configuration steps are omitted here.
2) Enable IP multicast routing, and enable PIM-DM and IGMP
# Enable IP multicast routing on Switch C, enable PIM-DM on each interface, and enable IGMP on the
host-side interface VLAN-interface 100.
[SwitchC] multicast routing-enable
[SwitchC] interface vlan-interface 100
[SwitchC-Vlan-interface100] igmp enable
[SwitchC-Vlan-interface100] pim dm
[SwitchC-Vlan-interface100] quit
[SwitchC] interface vlan-interface 101
[SwitchC-Vlan-interface101] pim dm
[SwitchC-Vlan-interface101] quit