H3C LS-3100-52P-OVS-H3 Operation Manual - page 985
1-34
To do...
Use the command...
Remarks
Configure the join/prune
interval
timer join-prune interval
Optional
60 seconds by default
Configure the join/prune
timeout time
holdtime join-prune interval
Optional
210 seconds by default
Configure assert timeout time
holdtime assert interval
Optional
180 seconds by default
Configure the multicast source
lifetime
source-lifetime interval
Optional
210 seconds by default
Configuring PIM common timers on an interface
Follow these steps to configure PIM common timers on an interface:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Configure the hello interval
pim timer hello interval
Optional
30 seconds by default
Configure the maximum delay
between hello messages
pim triggered-hello-delay
interval
Optional
5 seconds by default
Configure the join/prune
interval
pim timer join-prune interval
Optional
60 seconds by default
Configure the join/prune
timeout time
pim holdtime join-prune
interval
Optional
210 seconds by default
Configure assert timeout time
pim holdtime assert interval
Optional
180 seconds by default
If there are no special networking requirements, we recommend that you use the default settings.
Configuring Join/Prune Message Sizes
A larger join/prune message size will result in loss of a larger amount of information when a message is
lost; with a reduced join/message size, the loss of a single message will bring relatively minor impact.
By controlling the maximum number of (S, G) entries in a join/prune message, you can effectively
reduce the number of (S, G) entries sent per unit of time.
Follow these steps to configure join/prune message sizes: