H3C LS-3100-52P-OVS-H3 Operation Manual - page 1845
1-34
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : FE90::10
2::10
Master IP : FE90::2
# Display detailed information of the VRRP group on Switch B.
[SwitchB-Vlan-interface3] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 2
Interface : Vlan-interface2
VRID : 1 Adver. Timer : 100
Admin Status : UP State : Backup
Config Pri : 100 Run Pri : 100
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : FE80::10
1::10
Master IP : FE80::1
Interface : Vlan-interface3
VRID : 2 Adver. Timer : 100
Admin Status : UP State : Master
Config Pri : 110 Run Pri : 110
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Virtual IP : FE90::10
2::10
Virtual MAC : 0000-5e00-0202
Master IP : FE90::2
The above information indicates that in VRRP group 1 Switch A is the master, Switch B is the backup
and hosts with the default gateway of 1::10/64 accesses the Internet through Switch A; in VRRP group
2 Switch A is the backup, Switch B is the master and hosts with the default gateway of 2::10/64
accesses the Internet through Switch B.
Multiple VRRP groups are commonly used in actual networking. In IPv6 network, to implement load
sharing among multiple VRRP groups, you need to manually configure the default gateway for hosts.