H3C LS-3100-52P-OVS-H3 Operation Manual - page 847
1-27
# Configure Switch B.
[SwitchB] bgp 100
[SwitchB-bgp] peer 10.1.0.100 as-number 100
[SwitchB-bgp] peer 10.1.0.100 bfd
[SwitchB-bgp] quit
3) Configure BFD parameters.
# Configure Switch A.
[SwitchA] bfd session init-mode active
[SwitchA-vlan10] interface Vlan-interface 10
[SwitchA-Vlan-interface10] bfd min-transmit-interval 300
[SwitchA-Vlan-interface10] bfd min-receive-interval 300
[SwitchA-Vlan-interface10] bfd detect-multiplier 7
[SwitchA-Vlan-interface10] bfd authentication-mode simple 1 zhang
[SwitchA-Vlan-interface10] quit
[SwitchA] quit
# Configure Switch B.
[SwitchB] bfd session init-mode active
[SwitchB-vlan10] interface Vlan-interface 10
[SwitchB-Vlan-interface10] bfd min-transmit-interval 300
[SwitchB-Vlan-interface10] bfd min-receive-interval 300
[SwitchB-Vlan-interface10] bfd detect-multiplier 6
[SwitchB-Vlan-interface10] bfd authentication-mode simple 1 zhang
4) Verify the configuration.
# Enable BFD debugging on Switch A.
# Display the detailed BFD neighbor information of Switch A.
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
Local Discr: 4 Remote Discr: 4
Source IP: 10.1.0.102 Destination IP: 10.1.0.100
Session State: Up Interface: Vlan10
Min Trans Inter: 300ms Act Trans Inter: 300ms
Min Recv Inter: 300ms Act Detect Inter: 2000ms
Recv Pkt Num: 52 Send Pkt Num: 50
Hold Time: 1600ms Connect Type: Direct
Establish Time: 02:42:53 Last Down Time: 02:42:53
Last Up Time: 02:42:53 Auth mode: None
Protocol: BGP
Diag Info: No Diagnostic