H3C LS-3100-52P-OVS-H3 Operation Manual - page 130
1-7
To do…
Use the command…
Remarks
Assign one or a group of
access ports to the current
VLAN
port interface-list
Required
By default, all ports belong to VLAN 1.
2) In interface or port group view
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group
view) to a VLAN:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer-2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter
interface
view or port
group view
Enter port
group view
port-group manual
port-group-name
Required
Use either command.
z
In Ethernet interface view,
the subsequent
configurations apply to the
current port.
z
In port group view, the
subsequent configurations
apply to all ports in the port
group.
z
In Layer-2 aggregate
interface view, the
subsequent configurations
apply to the Layer-2
aggregate interface and all
its member ports.
Configure the link type of the
port or ports as access
port link-type access
Optional
The link type of a port is access
by default.
Assign the current access
port(s) to a VLAN
port access vlan vlan-id
Optional
By default, all access ports
belong to VLAN 1.
z
Before assigning an access port to a VLAN, create the VLAN first.
z
After you configure a command on a Layer-2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do
that on the aggregate interface, it stops applying the configuration to the aggregation member ports.
If it fails to do that on an aggregation member port, it simply skips the port and moves to the next
port.
Assigning a Trunk Port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view or port group view.
Follow these steps to assign a trunk port to one or multiple VLANs: