H3C LS-3100-52P-OVS-H3 Operation Manual - page 938
1-16
To do...
Use the command...
Remarks
Configure IGMP fast leave
processing
fast-leave [ group-policy
acl-number ]
Required
Disabled by default
The IGMP fast leave processing configuration is effective only if the device is running IGMPv2 or
IGMPv3.
Configuring IGMP SSM Mapping
Due to some possible restrictions, some receiver hosts on an SSM network may run IGMPv1 or
IGMPv2. To provide SSM service support for these receiver hosts, you need to configure the IGMP
mapping feature on the last hop router.
Configuration Prerequisites
Before configuring the IGMP SSM mapping feature, complete the following tasks:
z
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
z
Configure basic functions of IGMP.
Enabling SSM Mapping
Follow these steps to enable the IGMP SSM mapping feature:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Enable the IGMP SSM
mapping feature
igmp ssm-mapping enable
Required
Disabled by default
To ensure SSM service for all hosts on a subnet, regardless of the IGMP version running on the hosts,
enable IGMPv3 on the interface that forwards multicast traffic onto the subnet.
Configuring SSM Mappings
By performing this configuration multiple times, you can map a multicast group to different multicast
sources.