H3C LS-3100-52P-OVS-H3 Operation Manual - page 1224
1-17
With the MLD report suppression function enabled, within a query interval, the Layer 2 device forwards
only the first MLD report of an IPv6 group to the Layer 3 device and will not forward the subsequent
MLD reports from the same multicast group to the Layer 3 device. This helps reduce the number of
packets being transmitted over the network.
Follow these steps to configure MLD report suppression:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter MLD Snooping view
mld-snooping
—
Enable MLD report
suppression
report-aggregation
Optional
Enabled by default
Configuring Maximum Multicast Groups that Can Be Joined on a Port
By configuring the maximum number of IPv6 multicast groups that can be joined on a port or a group of
ports, you can limit the number of multicast programs available to VOD users, thus to control the traffic
on the port.
Follow these steps configure the maximum number of IPv6 multicast groups that can be joined on a port
or a group of ports:
To do...
Use the command...
Remarks
Enter system view
system-view
—
interface interface-type
interface-number
Enter Ethernet port/Layer 2
aggregate port view or port
group view
port-group manual
port-group-name
Required
Use either approach
Configure the maximum
number of IPv6 multicast
groups that can be joined on a
port
mld-snooping group-limit
limit [ vlan vlan-list ]
Optional
512 by default.