H3C LS-3100-52P-OVS-H3 Operation Manual - page 59
1-7
Configuring a Dynamic Aggregation Group
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Set the system LACP
priority
lacp system-priority
system-priority
Optional
By default, the system LACP priority is
32768.
Changing the system LACP priority
may affect the selected/unselected
state of the ports in the dynamic
aggregation group.
Create a Layer 2
aggregate interface and
enter the Layer 2
aggregate interface view
interface
bridge-aggregation
interface-number
Required
When you create a Layer 2 aggregate
interface, a Layer 2 static aggregation
group numbered the same is created
automatically.
Configure the
aggregation group to
work in dynamic
aggregation mode
link-aggregation mode
dynamic
Required
By default, an aggregation group
works in static aggregation mode.
Exit to system view
quit
—
Enter Layer 2 Ethernet
interface view
interface interface-type
interface-number
Assign the Ethernet
interface to the
aggregation group
port link-aggregation group
number
Required
Repeat the two steps to assign multiple
Ethernet interfaces to the aggregation
group.
Assign the port a LACP
priority
lacp port-priority
port-priority
Optional
By default, the LACP priority of a port is
32768.
Changing the LACP priority of a port
may affect the selected/unselected
state of the ports in the dynamic
aggregation group.