H3C LS-3100-52P-OVS-H3 Operation Manual - page 1132
1-23
[SwitchB-Vlan-interface200] pim ipv6 dm
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 201
[SwitchB-Vlan-interface201] pim ipv6 dm
[SwitchB-Vlan-interface201] quit
# Enable IPv6 multicast routing on Switch C, enable IPv6 PIM-DM on each interface, and enable MLD
on VLAN-interface 200.
[SwitchC] multicast ipv6 routing-enable
[SwitchC] interface vlan-interface 200
[SwitchC-Vlan-interface200] mld enable
[SwitchC-Vlan-interface200] pim ipv6 dm
[SwitchC-Vlan-interface200] quit
[SwitchC] interface vlan-interface 202
[SwitchC-Vlan-interface202] pim ipv6 dm
[SwitchC-Vlan-interface202] quit
3) Verify the configuration
Carry out the display mld interface command to display the MLD configuration and running
information on each switch interface. Example:
# Display MLD information on VLAN-interface 200 of Switch B.
[SwitchB] display mld interface vlan-interface 200
Vlan-interface200(FE80::200:5EFF:FE66:5100):
MLD is enabled
Current MLD version is 1
Value of query interval for MLD(in seconds): 125
Value of other querier present interval for MLD(in seconds): 255
Value of maximum query response time for MLD(in seconds): 10
Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
Total 1 MLD Group reported
MLD SSM Mapping Configuration Example
Network requirements
z
On the IPv6 PIM-SSM network shown in
Figure 1-8
, the receiver host receives VOD information
through multicast. The receiver runs MLDv1, so it cannot specify the expected IPv6 multicast
sources in its reports.
z
It is required that MLD SSM mapping be configured on Switch D so that the receiver host will
receive IPv6 multicast data from Source 1 and Source 3 only.