H3C LS-3100-52P-OVS-H3 Operation Manual - page 1050
1-11
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enable BGP route refresh for a
peer/peer group
peer { group-name | ip-address }
capability-advertise route-refresh
Optional
Enabled by default
Perfom a manual soft reset
If the peer does not support route-refresh, you can use the peer keep-all-routes command to save all
the route updates from the peer, and then use the refresh bgp ipv4 multicast command to soft-reset
MBGP connections to refresh the MBGP routing table and apply the new policy without tearing down
MBGP connections.
Follow these steps to configure MBGP manual soft reset
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Disable BGP route-refresh and
multi-protocol extensions for a
peer/peer group
peer { group-name | ip-address }
capability-advertise conventional
Optional
Enabled by default
Enter IPv4 MBGP address
family view
ipv4-family multicast
—
Keep all original routes from a
peer/peer group regardless of
whether they pass the inbound
filtering policies
peer { group-name | ip-address }
keep-all-routes
Required
Not kept by default
Return to user view
return
—
Soft-reset MBGP connections
manually
refresh bgp ipv4 multicast { all |
ip-address | group group-name |
external | internal } { export | import }
Optional
Configuring the Maximum Number of MBGP Routes for Load Balancing
Follow these steps to configure the number of MBGP routes for load balancing:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv4 MBGP address
family view
ipv4-family multicast
—
Configure the maximum
number of MBGP routes for
load balancing
balance number
Required
Not configured by default.