H3C LS-3100-52P-OVS-H3 Operation Manual - page 1604
1-14
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.
Displaying and Maintaining Basic Configurations
To do…
Use the command…
Remarks
Display information on system version
display version
Display information on the system clock
display clock
Display information on terminal users
display users [ all ]
Display the valid configuration under
current view
display this [ by-linenum ]
Display clipboard information
display clipboard
Display and save statistics of each
module’s running status
display diagnostic-information
Available in
any view
During daily maintenance or when the system is operating abnormally, you need to view each module’s
running status to find the problem. Therefore, you are required to execute the corresponding display
commands one by one. To collect more information one time, you can execute the display
diagnostic-information command in any view to display or save statistics of each module’s running
status. The execution of the display diagnostic-information command has the same effect as that of
the commands display clock, display version, display device, and display current-configuration.
z
For the detailed description of the display users command, refer to Login Commands in the System
Volume.
z
Support for the display configure-user and display current-configuration command depends on the
device model.
z
The display commands discussed above are for the global configuration. Refer to the
corresponding section for the display command for specific protocol and interface.
CLI Features
This section covers the following topics:
z
Introduction to CLI
z
Online Help with Command Lines
z
Synchronous Information Output
z
Undo Form of a Command