H3C LS-3100-52P-OVS-H3 Operation Manual - page 795
1-18
To do…
Use the command…
Remarks
Configure the router as a route
reflector and specify an IPv6
peer/peer group as a client
peer { ipv6-group-name |
ipv6-address } reflect-client
Required
Not configured by default.
Enable route reflection
between clients
reflect between-clients
Optional
Enabled by default.
Configure the cluster ID of the
route reflector
reflector cluster-id cluster-id
Optional
By default, a route reflector
uses its router ID as the cluster
ID
z
In general, since the route reflector forwards routing information between clients, it is not required
to make clients of a route reflector fully meshed. If clients are fully meshed, it is recommended to
disable route reflection between clients to reduce routing costs.
z
If a cluster has multiple route reflectors, you need to specify the same cluster ID for these route
reflectors to avoid routing loops.