H3C LS-3100-52P-OVS-H3 Operation Manual - page 1263
2-8
Applying a QoS policy to online users
You can apply a QoS policy to traffic of multiple online users. You can apply only one policy in one
direction (inbound or outbound) of the traffic of online users. To modify a QoS policy already applied,
remove the QoS policy application first.
Follow these steps to apply a QoS policy to traffic of online users:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter user profile view
user-profile profile-name [ dot1x
| portal ]
Required
The configuration made in user
profile view takes effect when
the user-profile is active and
the corresponding users are
online.
Apply the QoS policy
qos apply policy policy-name
{ inbound | outbound }
Required
Return to system view
quit
—
Activate the user profile
user-profile profile-name enable
Required
Inactive by default.
z
When a user profile is active, you cannot configure or remove the QoS policy applied to it.
z
The QoS policies applied in user profile view support only the remark, car, and filter actions.
z
Do not apply an empty QoS policy in user profile view, because even if you can do that, the user
profile cannot be activated.
z
Refer to User Profile Configuration in the System Volume for more information about user profiles.
Applying a QoS policy to a VLAN
Follow these steps to apply the QoS policy to a VLAN:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Apply the QoS policy to the
specified VLAN(s)
qos vlan-policy policy-name vlan
vlan-id-list { inbound | outbound }
Required