H3C LS-3100-52P-OVS-H3 Operation Manual - page 138
1-15
To do...
Use the command…
Remarks
Display VLAN interface
information
display interface
vlan-interface
[ vlan-interface-id ]
Available in any view
Display hybrid ports or trunk
ports on the device
display port { hybrid | trunk }
Available in any view
Display MAC address-to-VLAN
entries
display mac-vlan { all |
dynamic | mac-address
mac-address [ mask
mac-mask ] | static | vlan
vlan-id }
Available in any view
Display all interfaces with
MAC-based VLAN enabled
display mac-vlan interface
Available in any view
Display protocol information
and protocol indexes of the
specified VLANs
display protocol-vlan vlan
{ vlan-id [ to vlan-id ] | all }
Available in any view
Display protocol-based VLAN
information on specified
interfaces
display protocol-vlan
interface { interface-type
interface-number [ to
interface-type
interface-number ] | all }
Available in any view
Display IP subnet-based VLAN
information and IP subnet
indexes of specified VLANs
display ip-subnet-vlan vlan
{ vlan-id [ to vlan-id ] | all }
Available in any view
Display the IP subnet-based
VLAN information and IP
subnet indexes of specified
ports
display ip-subnet-vlan
interface { interface-list | all }
Available in any view
Clear statistics on a port
reset counters interface
[ interface-type
[ interface-number ] ]
Available in user view
The reset counters interface command can be used to clear statistics on a VLAN interface. For more
information, refer to Ethernet Interface Commands in the Access Volume.
VLAN Configuration Example
Network requirements
z
Device A connects to Device B through a trunk port GigabitEthernet 1/0/1;
z
The default VLAN ID of GigabitEthernet 1/0/1 is 100;
z
GigabitEthernet 1/0/1 allows packets from VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to
pass through.