H3C LS-3100-52P-OVS-H3 Operation Manual - page 1157
1-17
Task
Remarks
Configuring a C-BSR
Optional
Configuring an IPv6 PIM domain border
Optional
Configuring C-BSR parameters globally
Optional
Configuring a BSR
Configuring C-BSR timers
Optional
Configuring IPv6 Multicast Source Registration
Optional
Disabling SPT Switchover
Optional
Configuring IPv6 PIM Common Features
Optional
Configuration Prerequisites
Before configuring IPv6 PIM-SM, complete the following task:
z
Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SM, prepare the following data:
z
The IP address of a static RP and an ACL rule defining the range of IPv6 multicast groups to be
served by the static RP
z
C-RP priority and an ACL rule defining the range of IPv6 multicast groups to be served by each
C-RP
z
A legal C-RP address range and an ACL rule defining the range of IPv6 multicast groups to be
served
z
C-RP-Adv interval
z
C-RP timeout
z
C-BSR priority
z
Hash mask length
z
An IPv6 ACL rule defining a legal BSR address range
z
BS period
z
BS timeout
z
An IPv6 ACL rule for register message filtering
z
Register suppression time
z
Register probe time
z
The IPv6 ACL rule and sequencing rule for SPT switchover
Enabling IPv6 PIM-SM
With IPv6 PIM-SM enabled, a router sends hello messages periodically to discover IPv6 PIM neighbors
and processes messages from the IPv6 PIM neighbors. When deploying an IPv6 PIM-SM domain, you
are recommended to enable IPv6 PIM-SM on all non-border interfaces of the routers.
Follow these steps to enable IPv6 PIM-SM:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enable IPv6 multicast routing
multicast ipv6 routing-enable
Required
Disable by default