H3C LS-3100-52P-OVS-H3 Operation Manual - page 1165
1-25
To do...
Use the command...
Remarks
Apply the ACL for initiating an
SPT switchover
spt-switch-threshold infinity
[ group-policy acl6-number
[ order order-value ] ]
Optional
By default, the device switches
to the SPT immediately after it
receives the first IPv6 multicast
packet
Configuring IPv6 PIM-SSM
The IPv6 PIM-SSM model needs the support of MLDv2. Therefore, be sure to enable MLDv2 on IPv6
PIM routers with receivers attached to them.
IPv6 PIM-SSM Configuration Task List
Complete these tasks to configure IPv6 PIM-SSM:
Task
Remarks
Enabling IPv6 PIM-SM
Required
Configuring the IPv6 SSM Group Range
Optional
Configuring IPv6 PIM Common Features
Optional
Configuration Prerequisites
Before configuring IPv6 PIM-SSM, complete the following task:
z
Configure any IPv6 unicast routing protocol so that all devices in the domain are interoperable at
the network layer.
Before configuring IPv6 PIM-SSM, prepare the following data:
z
The IPv6 SSM group range
Enabling IPv6 PIM-SM
The SSM model is implemented based on some subsets of IPv6 PIM-SM. Therefore, a router is IPv6
PIM-SSM capable after you enable IPv6 PIM-SM on it.
When deploying an IPv6 PIM-SM domain, you are recommended to enable IPv6 PIM-SM on all
non-border interfaces of routers.