H3C LS-3100-52P-OVS-H3 Operation Manual - page 1765
1-17
To do…
Use the command…
Remarks
Configure the advantage factor
for calculating MOS and ICPIF
values
advantage-factor factor
Optional
By default, the advantage
factor is 0.
Specify the source IP address
for the requests in a test
operation
source ip ip-address
Optional
By default, no source IP
address is specified.
The source IP address must be
that of an interface on the
device and the interface must
be up. Otherwise, the test will
fail.
Specify the source port number
for the requests in a test
operation
source port port-number
Optional
By default, no source port
number is specified.
Configure the size of a probe
packet to be sent
data-size size
Optional
By default, the probe packet
size depends on the codec
type. The default packet size is
172 bytes forG.711A-law and
G.711 µ-lawcodec type, and is
32 bytes for G.729 A-law codec
type.
Configure the filler string of a
probe packet sent
data-fill string
Optional
By default, the filler string of a
probe packet is the
hexadecimal number
00010203040506070809.
Configure the number of
packets sent in a voice probe
probe packet-number
packet-number
Optional
1000 by default.
Configure the interval for
sending packets in a voice
probe
probe packet-interval
packet-interval
Optional
20 milliseconds by default.
Configure the timeout for
waiting for a response in a
voice test
probe packet-timeout
packet-timeout
Optional
5000 milliseconds by default.
Configure common optional
parameters
See
Configuring Optional
Parameters Common to an
NQA Test Group
Optional
Only one probe can be made in one voice test, and the number of probe packets sent in each probe
depends on the configuration of the probe packet-number command.
Configuring a DLSw Test
A DLSw test is used to test the response time of the DLSw device.