H3C LS-3100-52P-OVS-H3 Operation Manual - page 808
1-6
Creating a Route Policy
Follow these steps to create a route policy:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create a route policy, specify a
node for it and enter route
policy node view
route-policy route-policy-name { permit |
deny } node node-number
Required
z
If a route policy node has the permit keyword specified, routing information matching all the
if-match clauses of the node will be handled using the apply clauses of this node, without needing
to match against the next node. If routing information does not match the node, it will go to the next
node for a match.
z
If a route policy node has the deny keyword specified, the apply clauses of the node will not be
executed. When routing information matches all the if-match clauses of the node, it cannot pass
the node, or go to the next node. If route information cannot match all the if-match clauses of the
node, it will go to the next node for a match.
z
When a route policy has more than one node, at least one node should be configured with the
permit keyword. If the route policy is used to filter routing information, routing information that does
not meet any node cannot pass the route policy. If all nodes of the route policy are set with the
deny keyword, no routing information can pass it.
Defining if-match Clauses
Follow these steps to define if-match clauses for a route-policy node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter route policy node view
route-policy route-policy-name
{ permit | deny } node
node-number
Required
Match IPv4 routing
information
specified in the
ACL
if-match acl acl-number
Match IPv4 routing
information
specified in the IP
prefix list
if-match ip-prefix ip-prefix-name
Optional
Not configured by
default.
Define match
criteria for IPv4
routes
Match IPv4 routing
information whose
next hop or source
is specified in the
ACL or IP prefix list
if-match ip { next-hop |
route-source }{ acl acl-number |
ip-prefix ip-prefix-name }
Optional
Not configured by
default.